Welcome! Log In Create A New Profile

Advanced
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5
September 30, 2012 06:05AM
well to be very accurate:

i downloaded the 64179.dat file as i though philip suggested.
i then put it into MLcad, there is shown as it should be.
then i put in the program the two parts as seen with this result.
after this happened i saved the outcome as the 64179.dat file as its uploaded.

the original 64179.dat file contains visualy only the 5x7 technic beam.
the two pins come from the MLCad programm.

rempie
SubjectAuthorViewsPosted
64179 Technic Beam 5 x 7 with Open Center 3 x 5 Remco Canten701September 24, 2012 12:38PM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Philippe Hurbain539September 25, 2012 12:18AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Remco Canten325September 28, 2012 01:19PM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Max Martin Richter401September 28, 2012 01:34PM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Remco Canten341September 28, 2012 01:44PM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Max Martin Richter468September 28, 2012 02:14PM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Philippe Hurbain418September 29, 2012 09:28AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Attachments Remco Canten387September 30, 2012 05:11AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Steffen364September 30, 2012 05:32AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Remco Canten422September 30, 2012 06:05AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Steffen386September 30, 2012 06:29AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Philippe Hurbain416September 30, 2012 07:41AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Steffen387September 30, 2012 11:50AM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Remco Canten365October 01, 2012 02:55PM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Steffen333October 01, 2012 04:03PM
Re: 64179 Technic Beam 5 x 7 with Open Center 3 x 5 Magnus Forsberg433October 02, 2012 09:27AM



Sorry, only registered users may post in this forum.

Click here to login