Welcome! Log In Create A New Profile

Advanced
Re: LPub: Making an assembly larger than the page
avatarJuly 23, 2013 04:18PM
LDView doesn't have any command line options for camera panning, but it does allow you to set the model center (-ModelCenter=x,y,z). This can be used to achieve panning, but requires more math. (Note: LDView uses the calculated model center as the camera's look-at point, so providing an alternative value moves the look-at point.)

Edited 1 time(s). Last edit at 2013-07-23 04:20PM by Travis Cobbs.
SubjectAuthorViewsPosted
LPub: Making an assembly larger than the page Eric Albrecht688July 16, 2013 10:37AM
Re: LPub: Making an assembly larger than the page Philippe Hurbain183July 16, 2013 12:48PM
Re: LPub: Making an assembly larger than the page Eric Albrecht182July 16, 2013 05:34PM
Re: LPub: Making an assembly larger than the page Philippe Hurbain182July 17, 2013 01:39AM
Re: LPub: Making an assembly larger than the page Eric Albrecht183July 22, 2013 01:15PM
Re: LPub: Making an assembly larger than the page Gerald Lasser177July 22, 2013 11:43PM
Re: LPub: Making an assembly larger than the page Eric Albrecht172July 23, 2013 01:53PM
Re: LPub: Making an assembly larger than the page Gerald Lasser172July 23, 2013 03:17PM
Re: LPub: Making an assembly larger than the page Travis Cobbs171July 23, 2013 04:18PM
Re: LPub: Making an assembly larger than the page Gerald Lasser187July 18, 2013 03:26AM
Re: LPub: Making an assembly larger than the page Eric Albrecht178July 23, 2013 01:57PM
Re: LPub: Making an assembly larger than the page Travis Cobbs323July 23, 2013 04:26PM



Sorry, only registered users may post in this forum.

Click here to login