Welcome! Log In Create A New Profile

Advanced
whitespace deals.. 0//
Previous Message Next Message
Forum List Message List New Topic Print View
Santeri Piippo
March 15, 2013 01:34PM
So I was working on my little parts authoring tool (ldforge) again and ran into a little problemo: is there required to be a whitespace after the numeric code for comments? Is a line like "0// edge lines" valid or are they considered errorneous?

I would assume it's illegal but assuming is bad, so yeah. The specification doesn't seem to mention anything about this, maybe I am blind as usual?

Edited 2 time(s). Last edit at 2013-03-15 01:36PM by Santeri Piippo.
Reply Quote
RSS
SubjectAuthorViewsPosted
whitespace deals.. 0// Santeri Piippo144March 15, 2013 01:34PM
Re: Numeric code whitespaces? Michael Heidemann102March 15, 2013 01:38PM
Re: whitespace deals.. 0// Santeri Piippo107March 15, 2013 02:16PM



Sorry, only registered users may post in this forum.

Click here to login

GeneralModels and PartsLDraw ProgramsAdministrativeOff Topic Recent Messages
LDraw.org AnnouncementsGeneral LDraw.org DiscussionHelp
MOCs (My Own Creations)Official ModelsRendering TechniquesParts Authoring and Official File StandardsPart Requests
LDraw Editors and ViewersLDraw File Processing and ConversionParts Author ToolsAll Other Programs.
Website Suggestions/Requests/DiscussionStandards CommitteeTheme Test Forum
Off-Topic