Welcome! Log In Create A New Profile

Advanced
Re: Decreasing poly count on models
April 25, 2013 01:05AM
no no the rendering was fast, it was the preprocessing that took ages
SubjectAuthorViewsPosted
Decreasing poly count on models Nicola1062February 14, 2013 08:17AM
Re: Decreasing poly count on models Travis Cobbs336February 14, 2013 09:06AM
Re: Decreasing poly count on models Roland Melkert311February 14, 2013 10:18AM
Re: Decreasing poly count on models Nicola345February 15, 2013 12:25AM
Re: Decreasing poly count on models Tim Gould292February 14, 2013 12:34PM
Re: Decreasing poly count on models Michael Horvath346February 26, 2013 04:28AM
Re: Decreasing poly count on models Vincent Majorczyk314April 11, 2013 09:56AM
Re: Decreasing poly count on models Nicola279April 11, 2013 10:11AM
Re: Decreasing poly count on models Tim Gould278April 11, 2013 12:35PM
Re: Decreasing poly count on models Ben Supnik263April 11, 2013 01:51PM
Re: Decreasing poly count on models Nicola240April 11, 2013 01:57PM
Re: Decreasing poly count on models Tim Gould277April 11, 2013 02:18PM
Re: Decreasing poly count on models Nicola250April 12, 2013 05:19AM
Re: Decreasing poly count on models Ben Supnik291April 12, 2013 10:38AM
Re: Decreasing poly count on models Paul Griffin261April 12, 2013 10:12PM
Re: Decreasing poly count on models Steffen105November 23, 2013 04:14AM
Re: Decreasing poly count on models Michael Heidemann104November 23, 2013 04:39AM
Re: Decreasing poly count on models Philippe Hurbain113November 24, 2013 07:57AM
Re: Decreasing poly count on models Michael Heidemann178November 24, 2013 08:06AM
Re: Decreasing poly count on models Nicola302April 24, 2013 05:35AM
Re: Decreasing poly count on models Ben Supnik303April 24, 2013 09:16PM
Re: Decreasing poly count on models Nicola350April 25, 2013 01:05AM
Re: Decreasing poly count on models Michael Horvath192October 21, 2013 06:48PM
Re: Decreasing poly count on models Antonio Cort├ęs Carrillo135November 23, 2013 02:14AM
Re: Decreasing poly count on models Michael Heidemann132November 23, 2013 02:26AM



Sorry, only registered users may post in this forum.

Click here to login