Welcome! Log In Create A New Profile

Advanced
Re: Orientation of flex parts
avatarNovember 25, 2012 10:15AM
Very nice! Though realistically such flat cables would not bend in wide direction, they would rather twist and bend on thin side. But I guess that it's a matter of orienting properly constraints?
SubjectAuthorViewsPosted
Orientation of flex parts Roland Melkert739November 20, 2012 09:59AM
Re: Orientation of flex parts Steffen303November 20, 2012 12:25PM
Re: Orientation of flex parts Tim Gould331November 20, 2012 01:10PM
Re: Orientation of flex parts Roland Melkert247November 20, 2012 02:28PM
Re: Orientation of flex parts Michael Heidemann268November 21, 2012 02:27PM
Re: Orientation of flex parts Tim Gould248November 21, 2012 02:39PM
Re: Orientation of flex parts Roland Melkert300November 20, 2012 02:26PM
Re: Orientation of flex parts Steffen247November 20, 2012 04:10PM
Re: Orientation of flex parts Roland Melkert236November 21, 2012 09:34AM
Re: Orientation of flex parts Tim Gould251November 21, 2012 02:21PM
Re: Orientation of flex parts Roland Melkert243November 21, 2012 03:03PM
Re: Orientation of flex parts Philippe Hurbain288November 22, 2012 12:03AM
Re: Orientation of flex parts Tim Gould289November 22, 2012 01:13AM
Re: Orientation of flex parts Roland Melkert244November 22, 2012 10:17AM
Re: Orientation of flex parts Tim Gould319November 22, 2012 12:37PM
Re: Orientation of flex parts Roland Melkert267November 25, 2012 09:46AM
Re: Orientation of flex parts Philippe Hurbain267November 25, 2012 10:15AM
Re: Orientation of flex parts Roland Melkert328November 25, 2012 10:32AM
Re: Orientation of flex parts Travis Cobbs258November 20, 2012 06:53PM
Re: Orientation of flex parts Steffen262November 21, 2012 03:48PM



Sorry, only registered users may post in this forum.

Click here to login