Welcome! Log In Create A New Profile

Advanced
Re: Lines not on edges
avatarNovember 19, 2012 12:13PM
Got it. Yes, if you don't want to rewrite the part extensively, it should be OK as you described. But, in order of preference and complexity)...
- draw small line rectangle on top of big quad
- Separate use a rect primitive for the small rectangle, and properly build the surface around it (this is more or less what is presently done)
- Go one step further and separate the parts that make up this assembly.
For the record: Top part is 4771, bottom part (with latches that go through the rectangular holes) is 4772. Trans clear bulbs over lamps are 4769. Complete assembly is 73664.

...good luck on this one, there is (large) room for improvement ;)

Edited 2 time(s). Last edit at 2012-11-19 12:14PM by Philippe Hurbain.
SubjectAuthorViewsPosted
Lines not on edges Ignacio Fernandez Galvan429November 19, 2012 11:15AM
Re: Lines not on edges Philippe Hurbain236November 19, 2012 11:33AM
Re: Lines not on edges Ignacio Fernandez Galvan215November 19, 2012 11:40AM
Re: Lines not on edges Philippe Hurbain297November 19, 2012 12:13PM
Re: Lines not on edges Michael Heidemann181November 21, 2012 09:16AM
Re: Lines not on edges Steffen194November 21, 2012 03:44PM
Re: Lines not on edges Ignacio Fernandez Galvan272November 24, 2012 09:30AM



Sorry, only registered users may post in this forum.

Click here to login