Welcome! Log In Create A New Profile

Advanced
Brick underside naming scheme
July 06, 2014 02:53PM
Because it was pointed out, we have to agree on a scheme for the different underside variants. I want to discuss this here instead in the part tracker for a specific part:
http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/3245c.dat

some examples
-> description if there are variants available (stuff in brackets only optional if needed) * for currently used variant

3678a, 772, 3066
-> with Hollow Bottom
-> without (Centre) Bottom Stud(s)*

3794a, 3023, 3245a
-> with Bottom Stud(s)
-> with Bottom Cylinder(s)
-> with Closed Bottom Tube(s)

3678b, 3049a
-> with (Centre) Bottom Tube(s)*
-> with (Centre) Open Bottom Tube(s)

3245b
-> with Inside Axle Holder*
-> with Bottom Axle Holder

4460a (on the right: http://i59.tinypic.com/20rl0r7.jpg )
-> with Bottom Triangular Brackets
-> with Bottom Triangular Inverted Stud(s)

15573 (on the left: http://i59.tinypic.com/20rl0r7.jpg )
-> with Bottom Triangular Based Brackets
-> with Bottom Triangular Based Inverted Stud(s)
-> without Understud*

not created atm (in the middle: http://i59.tinypic.com/20rl0r7.jpg )
-> with Bottom Teeth Brackets
-> with Bottom Teeth Inverted Stud(s)

Imho the last three shouldn't be created if any other version already exists for a specific part. But if one is created one should be picked which is available for the part. So 15573 with "Teeth Brackets" or "Triangular Brackets" would be invalid (at the moment)

All are just suggestions - but I hope we can agree on some wording.
SubjectAuthorViewsPosted
Brick underside naming scheme Stephan Meisinger236July 06, 2014 02:53PM
Re: Brick underside naming scheme Stephan Meisinger73July 16, 2014 02:17PM
Re: Brick underside naming scheme Roland Melkert93July 17, 2014 09:12AM



Sorry, only registered users may post in this forum.

Click here to login