Part match up problem - Printable Version +- LDraw.org Discussion Forums (https://forums.ldraw.org) +-- Forum: General (https://forums.ldraw.org/forum-12.html) +--- Forum: Help (https://forums.ldraw.org/forum-13.html) +--- Thread: Part match up problem (/thread-23266.html) |
Part match up problem - Orion Pobursky - 2019-03-07 Attached is a snippet of an official model I am working on. The steering arms (2739a) and the steering links (6540b) should match up with the arms at 90 degrees. I'm posting this to see if this is a problem with one of the parts or if I'm doing something wrong. RE: Part match up problem - Philippe Hurbain - 2019-03-07 (2019-03-07, 18:18)Orion Pobursky Wrote: Attached is a snippet of an official model I am working on.My bet is that 6540b is slighly off. (6540a is the same). Distance in z direction between towball and pinhole is 22 ldu, I guess it should be 20ldu. RE: Part match up problem - Orion Pobursky - 2019-03-07 (2019-03-07, 18:47)Philippe Hurbain Wrote: My bet is that 6540b is slighly off. (6540a is the same). Distance in z direction between towball and pinhole is 22 ldu, I guess it should be 20ldu. I don't have this part but it's pretty cheap so I can order it. RE: Part match up problem - Philippe Hurbain - 2019-03-07 (2019-03-07, 18:57)Orion Pobursky Wrote: I don't have this part but it's pretty cheap so I can order it.Just checked, got it! I'll measure tomorrow ! RE: Part match up problem - Orion Pobursky - 2019-03-07 (2019-03-07, 20:45)Philippe Hurbain Wrote: Just checked, got it! I'll measure tomorrow ! I just ordered both versions so I can double check you. RE: Part match up problem - Magnus Forsberg - 2019-03-07 (2019-03-07, 18:47)Philippe Hurbain Wrote: My bet is that 6540b is slighly off. (6540a is the same). Distance in z direction between towball and pinhole is 22 ldu, I guess it should be 20ldu. I came to the same conclusion. Something is off by 2 ldu. It could be either the pin/axle hole or the towballs. RE: Part match up problem - Philippe Hurbain - 2019-03-08 (2019-03-07, 22:21)Magnus Forsberg Wrote: I came to the same conclusion. Something is off by 2 ldu. It could be either the pin/axle hole or the towballs.Clearly distance should be 20 x 70 ldu, not 22 x 70! https://photos.app.goo.gl/WEAjRxRjqAWTaJwRA Position of towballs vs. ring are OK. I'll correct... RE: Part match up problem - Philippe Hurbain - 2019-03-09 (2019-03-08, 9:48)Philippe Hurbain Wrote: Clearly distance should be 20 x 70 ldu, not 22 x 70! https://photos.app.goo.gl/WEAjRxRjqAWTaJwRA6540a and b now corrected on PT. |